Hi, I just got my Road Hog today, and like an idiot or better yet a kid at Christmas, I decided to go ahead and commit to using it at tonight's very busy show at my club. That said, I'm coming from using a Hog 500 where strobe is part of the beam menu and is easily changed from random to sync, etc. at any speed by the corresponding wheel. On the Road Hog, the only strobe panel is one of the slotted parameters and it only gives me open or closed options... nothing else. What do I do? Everything else is going well, but this show starts here in a few minutes and I need some advice asap... got two openers to try and figure it out. THanks.
Coming from a Hog 500, play around on the Road Hog. With the Hog 3 software, things are laid out "logically" instead of necessarily where the manufacturer put it. Along the lines of Golden Scans (and some other people) that put intensity and control on the same channel, the Hog 3 software splits it out so you don't have to worry about going "too far" and turning off the lamp or resetting the fixture.
Coming from a Hog 500, play around on the Road Hog. With the Hog 3 software, things are laid out "logically" instead of necessarily where the manufacturer put it. Along the lines of Golden Scans (and some other people) that put intensity and control on the same channel, the Hog 3 software splits it out so you don't have to worry about going "too far" and turning off the lamp or resetting the fixture.
