Timecode question

Hi there,

I work for several big fireworks and use smpte with Ipc (Hog3pc Mode).
As there are not offset command to adjust cuelist with timecode I used wheel encoder on Hog2. (select all cues and "set" and turn wheel until I have good time adress for cue. Result all others cues was "offseted")
I search this fonction on hog3, seems be disapear.
Any Idea?
(I have between 200 and 400 cues so impossible for me to enter new timecode adress for all of them)
Thanx
Parents
  • 0
    If you want to change the time-code for a single cue:
    In the wait-column select the timecode of the cue you want to change, press 'Set' and change the time. Now only this cue will change, not affecting the others.

    If you want to change all the cues with a certain offset, or a selection of cues (eg 85 till 120):
    Select the wait-column of all the cues or a selection of cues, now press 'Set' and change the timecode of the first cue, all other cues will offset with the same time.

    Hope this helps.

    Gr.
    Pim
Reply
  • 0
    If you want to change the time-code for a single cue:
    In the wait-column select the timecode of the cue you want to change, press 'Set' and change the time. Now only this cue will change, not affecting the others.

    If you want to change all the cues with a certain offset, or a selection of cues (eg 85 till 120):
    Select the wait-column of all the cues or a selection of cues, now press 'Set' and change the timecode of the first cue, all other cues will offset with the same time.

    Hope this helps.

    Gr.
    Pim
Children
No Data
Related

www.etcconnect.com