still no Visualizer Connecitivy for 3.0 for esp vision

still no Visualizer Connecitivy for 3.0 for esp vision ?????????:aargh4: :aargh4: :aargh4:
Parents
  • 0
    In the Network Control Panel there are no choices for HogNet Adapters. This is so frustration.
    this is due to fact that you have only one adapter active.

    So for now:
    1. Enable your Gigabit Ethernet Adaper to make up adapters list in HOGPC Network Control Panel.
    2. Check is your Microsoft Loopback Adapter up and running. If it has limited connection or another problem, set it TCP/IP Properties to any fixed address in your network, 192.168.0.255 for example.
    3. Focus in HOGPC Network Control Panel on the Loopback Adapter, select "Use default IP settings" and Apply. It will be switched to "Obtain an IP address using DHCP" and you will see correct IP than.

    Have fun.
Reply
  • 0
    In the Network Control Panel there are no choices for HogNet Adapters. This is so frustration.
    this is due to fact that you have only one adapter active.

    So for now:
    1. Enable your Gigabit Ethernet Adaper to make up adapters list in HOGPC Network Control Panel.
    2. Check is your Microsoft Loopback Adapter up and running. If it has limited connection or another problem, set it TCP/IP Properties to any fixed address in your network, 192.168.0.255 for example.
    3. Focus in HOGPC Network Control Panel on the Loopback Adapter, select "Use default IP settings" and Apply. It will be switched to "Obtain an IP address using DHCP" and you will see correct IP than.

    Have fun.
Children
No Data
Related

www.etcconnect.com