There are running 2 DP2000 (these are running perfectly)
I’ve recently linkt up a DP8000, and want to test this device.
The DP8000 was running V3.0.0, I forced the DP8000 to load the V3.0.5 software by pressing the 3 buttons at once while powering the device. This works perfect.
The DP8000 is running V3.0.5 (shown in the control panel Hog 3V3.0.5(b2482))
The DP8000 loads the new software but I don’t can get it running.
The display on the DP8000 shows: Connecting, No server, scanning port 6600. 4 The LED near Hog-Net Link is flashing
On the back of the DP8000 the Link LED is on, and the Traffic LED is flashing. (Hog-Net Gigabit – Ethernet)
All the IP addresses are starting with 172.031.000.XXX
All the DP’s are in the show.
I can’t get the DP8000 load the V3.1.0
I already forced the DP8000 to load V3.1.0 by pressing 3 buttons at once while powering the device. The DP8000 shows: FORCING SOFTWARE REALOD, and info is scrolling over the screen.
This takes a while and fans are running.
When I check the software in the control panel it still show’s HOG3V3.0.5 (b2482)
Yes I did install the HOGiPC DMX Processor 8000 Firmware into the IPC
The same problem accurse when I try this whit a Roadhog Full Boar.
All the IP addresses are starting with 172.031.000.XXX
All the DP’s are in the show.
I can’t get the DP8000 load the V3.1.0
I already forced the DP8000 to load V3.1.0 by pressing 3 buttons at once while powering the device. The DP8000 shows: FORCING SOFTWARE REALOD, and info is scrolling over the screen.
This takes a while and fans are running.
When I check the software in the control panel it still show’s HOG3V3.0.5 (b2482)
Yes I did install the HOGiPC DMX Processor 8000 Firmware into the IPC
The same problem accurse when I try this whit a Roadhog Full Boar.
