There are running 2 DP2000 (these are running perfectly)
I’ve recently linkt up a DP8000, and want to test this device.
The DP8000 was running V3.0.0, I forced the DP8000 to load the V3.0.5 software by pressing the 3 buttons at once while powering the device. This works perfect.
The DP8000 is running V3.0.5 (shown in the control panel Hog 3V3.0.5(b2482))
The DP8000 loads the new software but I don’t can get it running.
The display on the DP8000 shows: Connecting, No server, scanning port 6600. 4 The LED near Hog-Net Link is flashing
On the back of the DP8000 the Link LED is on, and the Traffic LED is flashing. (Hog-Net Gigabit – Ethernet)
After you upgraded and restarted your IPC did you turn ON Run DHCP? When you upgrade the ipc this will defaut to obtain an ip. Turn Run DCHP on, restart your desk and try again.
Did you upgrade the IPC Config Panel as well?
We currently have no way of telling the user what version of the IPC_DP8K app is installed.
If this does not work, you can try to force the image onto the DP8K. Launch a new show without the DP powered on. Power on the DP and hold down all 3 buttons, after a few seconds you should see IO disconnect and then a bunch of dots will start scrolling on the display. This mean the 8K is updating.
After you upgraded and restarted your IPC did you turn ON Run DHCP? When you upgrade the ipc this will defaut to obtain an ip. Turn Run DCHP on, restart your desk and try again.
Did you upgrade the IPC Config Panel as well?
We currently have no way of telling the user what version of the IPC_DP8K app is installed.
If this does not work, you can try to force the image onto the DP8K. Launch a new show without the DP powered on. Power on the DP and hold down all 3 buttons, after a few seconds you should see IO disconnect and then a bunch of dots will start scrolling on the display. This mean the 8K is updating.
