iPC DMX and Ethernet ?

I assume when you mention "ethernet" you are asking about ArtNet.
The only way to have ArtNet with an iPC is to add a DP-8000 to your system.

Hope this helps. :)

[QUOTE=Marty Postma;52026]I assume when you mention "ethernet" you are asking about ArtNet.
The only way to have ArtNet with an iPC is to add a DP-8000 to your system.

Hope this helps. :)

thanks marty,

i was a bit confused, becouse hogpc software on the ipc says there is a
dp8000 installed.

i never used a hog to run a mediaserver, well my next question is...
where do i patch the (hippotizer) on hogpc? i see 16 universes, the first 3
are for dmx (lights)
thanks again
marc

Don't confuse the DP-8000 process with an actual DP-8000.
The iPC only has 4 univeses available (with no add-ons) all of which are only "accessable" via 5-pin DMX cables.

The only way to get DMX to the Hippo with your current config is to take a 5-pin DMX cable from your Port #4 of the iPC and go in that way. Then patch accordingly.

Hope this helps. :)

thanks marty, so i will use a dmx to artnet converter.

marc

That will work too. ;)
Happy to help clarify things a bit for you.