• State Not Answered
  • Date
    marcs - Former HES Forum Member
  • Date
  • Replies 5 replies
  • Subscribers 5 subscribers
  • Views 225 views
  • Users 0 members are here

iPC DMX and Ethernet ?

Hey,

i have a question in case of planning a show:
is it possible to run on a iPC 3 DMX lines for lights and
at the same time the ethernet for mediaserver?
if so, how to patch? ..the first 4 universes are dmx the
next are ethernet?
if not, what do i need? another dp?

thanks in advance

marc
Parents
  • 0
    [QUOTE=Marty Postma;52026]I assume when you mention "ethernet" you are asking about ArtNet.
    The only way to have ArtNet with an iPC is to add a DP-8000 to your system.

    Hope this helps. :)

    thanks marty,

    i was a bit confused, becouse hogpc software on the ipc says there is a
    dp8000 installed.

    i never used a hog to run a mediaserver, well my next question is...
    where do i patch the (hippotizer) on hogpc? i see 16 universes, the first 3
    are for dmx (lights)
    thanks again
    marc
Reply
  • 0
    [QUOTE=Marty Postma;52026]I assume when you mention "ethernet" you are asking about ArtNet.
    The only way to have ArtNet with an iPC is to add a DP-8000 to your system.

    Hope this helps. :)

    thanks marty,

    i was a bit confused, becouse hogpc software on the ipc says there is a
    dp8000 installed.

    i never used a hog to run a mediaserver, well my next question is...
    where do i patch the (hippotizer) on hogpc? i see 16 universes, the first 3
    are for dmx (lights)
    thanks again
    marc
Children
No Data
Related

www.etcconnect.com