Problem with strobe

Okay this probably has a simple solution, and Im just not seeing something.

I have a template page with a pretty standard strobe cue of Int=100 Rate=10hz Length=0

when I try to make a separate cue with max length (for a blinding look), it changes the first cue to the same settings. Even if the new cue is released.

And then if I delete the new cue, the original cue only blinks the strobe once, but after a while goes back to what was originally programmed...

Im using a Road Hog FB with pretty new softawre and the strobes are Martin Atomics in mode 4.

Thanks for the help!
Parents
  • 0
    Select strobe group

    (using encoder wheels) Intensity to 100 rate to 10hz

    "record"

    "choose" (master 7)

    "clear"

    Select strobe group

    (using encoder wheels) Intensity to 100 rate to 10hz length to 2sec.

    "record"

    "choose" (master 10)

    "clear"
    ------

    After that both flashes (masters 7 and 10) have the blinding effect of a long strobe length and high rate that was intended for only master 10.

    no change if master 10 is released

    If I delete Master 10 then master 7 only flashes the strobe once.
Reply
  • 0
    Select strobe group

    (using encoder wheels) Intensity to 100 rate to 10hz

    "record"

    "choose" (master 7)

    "clear"

    Select strobe group

    (using encoder wheels) Intensity to 100 rate to 10hz length to 2sec.

    "record"

    "choose" (master 10)

    "clear"
    ------

    After that both flashes (masters 7 and 10) have the blinding effect of a long strobe length and high rate that was intended for only master 10.

    no change if master 10 is released

    If I delete Master 10 then master 7 only flashes the strobe once.
Children
No Data
Related

www.etcconnect.com