Artnet to Hippotizer

Howdy all,

in a bit of a stick and hoping one of you hog gurus can help me out

Basically i am trying to run my Road Hog Full Boar via artnet to a hippotizer V3 Critter

Being the critter it is a smaller version of the V3 and does not have a direct DMX in, therefore must be run via Artnet.

I am totally inexperience in running hog Ethernet systems, and to be honest reading the manual made my confusion worse.

Anyone done this? or have any tips/tricks for me

Harro

Parents

0 abbe rpm digital lighting - Former HES Forum Member over 13 years ago

Hi,

I think the HOG is the lightingsystem that you require the least possible knowledge about ArtNet to have it working.

Just open a new show, patch the Hippo from one on DMX one and make sure they both have IP Adresses in the same range and it should work.

Give that a try and then ask again :)

Good luck
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 abbe rpm digital lighting - Former HES Forum Member over 13 years ago

Hi,

I think the HOG is the lightingsystem that you require the least possible knowledge about ArtNet to have it working.

Just open a new show, patch the Hippo from one on DMX one and make sure they both have IP Adresses in the same range and it should work.

Give that a try and then ask again :)

Good luck
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data