I'm trying to load 3.2.2 on my rackmount 3 backup system and cannot get the unit into boot mode. Neither USB keyboard nor programmer widget prevent standard boot up. When the new software disc is in drive at start up the console cannot complete start up procedure at all. Any ideas?
No. The board literally restarts. Screens go black and then the board boots up again. Only I don't have to hold Ctrl down to get to the boot menu. It automatically restores to the boot menu. The disc is good. I've used it to update another console. Independent of all of this, if I start the board with this or any disc in the drive, the board doesn't start, just continues to fail to start over and over.
No. The board literally restarts. Screens go black and then the board boots up again. Only I don't have to hold Ctrl down to get to the boot menu. It automatically restores to the boot menu. The disc is good. I've used it to update another console. Independent of all of this, if I start the board with this or any disc in the drive, the board doesn't start, just continues to fail to start over and over.
