When using HTP on a fader cue list. There are values 'lingering around' after it has been replaced or removed.
Setup: 3 generic dimmers patched in. Fixture Numbers 41 thru 43.
To recreate problem:
Grab fixtures 41 thru 43 @ FULL.
RECORD CHOOSE 9.
Set LIST options to USE HTP. (CHOOSE CHOOSE [Options] "Use HTP" )
You now control the fader, and it brings fixtures 41 thru 43 up and down.
CLEAR Programer.
Grab fixtures 41 and 42 @ FULL
RECORD CUE 1 CHOOSE 9. And choose [Replace] to replace the original cue.
CLEAR Programer
Now control the fader up and down. Notice, Fixture 43 is still controlled.
--
With CHOOSE 9 selected. CUE 1 DELETE.
Grab fixtures 41 and 42 @ FULL
RECORD CUE 1 CHOOSE 9. And choose [Replace] to replace the original cue.
CLEAR Programer
Once again, even thou you completely removed the cue. And completely rewrote it. Control of fixture 43 still remains.
---
It is not until you go back to the Cue List OPTIONS and uncheck 'USE HTP' and Re-check mark 'USE HTP' will this glitch be removed.
---
Similar issue. Deleting a CUE list from a fader does NOT release it.
Press and hold DELETE + CHOOSE 9. Cue List gets removed from the Fader. Yet look at your OUTPUT. 41 thu 43 still at FULL.
---
see:youtu.be/czUJenB51iU
