Lamp Strike

Hi there -

Actual VL6 fixtures with DMX power packs? Or APS6 modules? 

Thanks much -

Sarah

Hi Gary -

Well, I've checked it in SmartSoft and it appears that the VL6 library item supports the reset command (33% for 3 seconds then out) but lamp on and lamp off are not (because the DPP was a reasonably rare beast). However, the reset channel is on User5 in the parameter controls. Record a memory with all lights in open white and the heads tilted parallel to the floor, with User5 at 99 percent. Record another one with the heads in the same position and the User5 parameter at 66 percent. When you want to strike, press and hold the bump button for the strike memory (User5 at 99%) for three seconds then let go. The lamps should strike. To douse, do the same but with the 66% memory. Don't use the faders - the channel has to snap off for the commands to work.

I hope this helps...

Thanks -

Sarah

I recommend having this on hand: