Can't Install box_1_src - Please Help

Hi All,

Thanks in advance.

Managed to get the test sketch and library onto the Arduino no problem but when I open the box 1 file (it opens in the IDE fine but will not upload to the device) I get an Orange Error code which reads - "Error Compiling for board Arduino" and then "exit status 1"

Can anyone help?

Best Wishes, Mike

0 sstaub over 5 years ago

Did you install the OSC libray? If not install it with the library manager. Have you chosen the right board? Which OS, which IDE version?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Mike Robertson over 5 years ago in reply to sstaub

Hello there, thanks for the help. I deleted everything and tried again and it appears to work. I will write an idiot's guide as a lot of folk would not know what the IDE is for example or that you need to download the Arduino software.

Rather a shame that it is only pan and tilt. Do you think there could be an update whereby colour and form parameters, for example, could be selected and altered on these encoders?

Thanks and best wishes, Mike
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 sstaub over 5 years ago in reply to Mike Robertson

I've attached a code for stepping thru a parameter list using the last/next buttons. The code is a little bit critical, so it works only with a limited number of parameters, because an Arduino is very limited in USB capabilities. May be you need to shorten the parameter list. Let me know if it works.

lighthack_box_2.zip
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Mike Robertson over 5 years ago in reply to sstaub

Thank you so much, we will have a go with this next week. All the best, M
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 sstaub over 5 years ago in reply to Mike Robertson

@Mike, have you test my code? If yes I will publish at GitHub.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel