• State Suggested Answer
  • Date
    ntbutler
  • Date
  • Replies 4 replies
  • Answers 1 answer
  • Subscribers 65 subscribers
  • Views 5384 views
  • Users 0 members are here
Options
Related

Box 1 - not working on Element Console

Hi all.

I have built and adapted the box_1 project using an Arduino Nano and 3 encoders. Whilst I still have some code to fix up, I have tested it on my mac with ETCnomad and the encoders work fine there. However when I plug it in to my Element console it doesn't seem to connect at all.

I did try installing the Arduino IDE which hasn't helped, so I was wondering if there was anything else I should check? Both the desk and my nomad software are on version 2.7.4 and they are both running the same show file, and I have checked in the show settings that USB OSC control is enabled.

Kind regards

Nathan

Parents
  • 0

    OK, so after a bit of mucking around with different devices, it appears that the arduino nano that I have isn't arduino-genuine (although I was led to believe it was). My mac had no issues picking up the driver (which seems rare from my reading of knock-off arduino driver compatibility), but other Windows laptops couldn't create the com port until Windows Update had installed a different driver for that chip.

    All good now

Reply
  • 0

    OK, so after a bit of mucking around with different devices, it appears that the arduino nano that I have isn't arduino-genuine (although I was led to believe it was). My mac had no issues picking up the driver (which seems rare from my reading of knock-off arduino driver compatibility), but other Windows laptops couldn't create the com port until Windows Update had installed a different driver for that chip.

    All good now

Children
No Data

www.etcconnect.com