I see someones created code for a 6 fader wing box, is there any documentation for this like a components list and wiring diagram etc just like Box 1?
Hello, I have a interesting phenomenon. I made a 10 fader 20 button fader bank, this ik working fine on my Apple with Nomad, but not on WIN10 on a Surface Pro. I think this has probably to do with the PID VID ? Or should I look else where. I tested the WIN 10 nomad with a UNO with the USB test all working fine. The fader bank is using a Arduino micro original.
Maybe a driver problem. Is the Arduino IDE installed on the Surface?
Not the full IDE only the driver part, it is visible in WIN10
What says the diagnostic tab (99) when you attach your board?
There are no command comming in, with the USB test Uno it is working fine. And on the Apple the commands are working on both.
It is a driver problem but I can't help because I use macOS and have no Arduino Micro board.
I will try to install the full IDE maybe that helps, if not I will also try to make the Micro in to a UNO as a work around. If I find the solution I will report back
Thank you so far
It is usually the micro driver causing issue. You have to make sure you have the appropriate usb driver for the chipset in your micro for your operating system version.
The original micro have no extern USB chipset, USB is build in the 32U4 microcontroller. I can remember that I have also had problems with macOS. Maybe you replace with the Nano Every(only 8 Ananlog Inputs) .
Hello, the nano is a no go, that means I have to rebuild the whole thing including code. But it works fineon MAC OSX even without a IDE install, plug it in and it works. Somebody wanted to borrow it, he runs WIN 10, and that did not work. It is visible in WIN 10 device manager as micro. So I think I try the work around with the PIV VID and or the full IDE install.