Hi All,
Could anyone advise what are the correct lamp options for the S4 mini fixture?I can find no reference online as to replacement lamps.Tungsten 12v 50w, but which beam angle? 25, 38, etc
otherwise a doughnut beam may be created.
Led 12v 12w but again what is the best beam angle.
Any info would be appreciatedThanksP.
Hello Phil,the original Lamp for Tungsten S4 Mini is USHIO Eurostar IR - 12V 50W Flood 35°About the LED Lamp option, please check the following Support Article: https://support.etcconnect.com/ETC/Fixtures/Source_Four_Mini/Incandescent/Using_LED_MR16_lamps_with_Source_Four_Mini_Incandescent
I hope this Info help.Kind regards,Markus
HI Mark thanks for the info.
I have tried several tungsten lamps with a Phillips 24° giving the best results so far, with the flattest overall beam.
Not tried a gobo as yet.
As for the Led options, the units had 8.3w 38° 2700k when i purchased them.
This lamp produced an even flat beam, but was quite dim in comparison to the tungsten lamps.
Also the lower end of the dimmer curve was pure to say the least.
Cheers
Phil.
Hello Phil,
did you buy the fixture new or used? The S4 Mini (tungsten - with power supply) is not supplied with LED lamp.
If you use LED lamps, there is no guarantee that the shaper and gobos can be projected with sharp edge.If there are any issues you always can contact your local dealer as well. >>> https://www.etcconnect.com/Find-A-Dealer.aspx
Best,Markus
Hi Markus,
i bought used (excellent condition) fitted with the Led's lamps.
Now i understand, the Led version is a unit with a dedicated Led engine presumably none removable.
Any for sale claiming to be Led versions are probably Tung units with Led lamps fitted.
Many thanks
Correct :-)