I have a couple of CMY Spots that are displaying a tab error. I think in association with a color wheel, or a gobo wheel. If not, those are completely seperate errors. Any one know what a tab error is? Thanks.
If it isn't moving at all, You probably have a Driver Chip/Harness/Logic Card/Motor Problem
When the motor is plugged in and the fixture is on, does it feel like it is energized?
Can you swap the motor to a known working position? (Gobo 2?) Just to see if it works...
If the motor works in another position, I would swap the driver chips on the Logic card, and see if the problem chases the logic card, or the driver chip.
And if swapping the driver chip implies that the chip is OK, then you would need to send your logic card in for repair.
If it isn't moving at all, You probably have a Driver Chip/Harness/Logic Card/Motor Problem
When the motor is plugged in and the fixture is on, does it feel like it is energized?
Can you swap the motor to a known working position? (Gobo 2?) Just to see if it works...
If the motor works in another position, I would swap the driver chips on the Logic card, and see if the problem chases the logic card, or the driver chip.
And if swapping the driver chip implies that the chip is OK, then you would need to send your logic card in for repair.
