• State Not Answered
  • Date
    stages - Former HES Forum Member
  • Date
  • Replies 11 replies
  • Subscribers 13 subscribers
  • Views 1347 views
  • Users 0 members are here

trackspot beeping

Hello, I have a problem with a Trackspot (rev 3.2). After initialising one of the motors starts the two level beeping. Initialising goes OK, (wheels are coming in the home position). The personality switch is in the test position. I have tried other setups of this switch I have measured the lines up to IC 7 (74HC245) and it seems that everything is OK. I have already tried another uprocessor but the beeping stays.
What is the problem here ?
Parents
  • 0
    Removing the PCB in a trackspot is really easy, no desoldering neccessary. All you have to do to remove the xlr connectors is there is a little screw inside the connectors, use a flashlight to look inside. You have to turn the screw about 1/4 of a turn. There is one on both connectors. Then on the SCR's just undo the screw holding them down. Then remove the light shield between the lamp and circuit board, then remove all the silver screws holding the circuit board to the metal frame. Now you can slide the circuit board forward and lift it out.
Reply
  • 0
    Removing the PCB in a trackspot is really easy, no desoldering neccessary. All you have to do to remove the xlr connectors is there is a little screw inside the connectors, use a flashlight to look inside. You have to turn the screw about 1/4 of a turn. There is one on both connectors. Then on the SCR's just undo the screw holding them down. Then remove the light shield between the lamp and circuit board, then remove all the silver screws holding the circuit board to the metal frame. Now you can slide the circuit board forward and lift it out.
Children
No Data
Related

www.etcconnect.com