DL2 camera

if memory serves me right you need to:

1 - DL2; go from Camera out to
2 - DL2; Svideo in

then select file 255(?) to activate the camera in the #1 DL2. it has been 6-7 months since i was on a DL2 unit.

the manual is quite good as far as getting the camera output to work. just make sure you have a your cable coming out of camera out going into Svideo in.

your play back unit is dl2 #2.

hope this helps

Shahar,

In order to view the S-video capture, select media folder 255 and media file 1 on one of your graphics layers on the unit you wish to project from.

You may notice that your "projector" DL.2 is not showing the camera feed from the "camera" DL.2. If this is the case it means that your DL.2s are set to internal camera capture rather than external s-video capture. To remedy this:

1) Open the iris
2) Select "S-video capture" in the Motion library on the Hog (it is under one of the slot toolbar buttons "Capture")
3) Close the iris for about 10 seconds
4) Reopen the iris.

Make sure you do this on both of your DL.2s.

That should be it. Let us know if you have more questions.

Thanks,

cool i will try i will try it thanx a lot