White Lamp On error blinking

Is the projector lamp lit?

The lamp is not lit

That would indicate a problem with your lamp.
How many hours are on the lamp?
When is the last time the HEPA was replaced and the filters cleaned?
These are both things that could affect the lamp strike.

Another quick thing to check is the IEC cable on the back of the projector.
Pop off the back cover on the head and make sure that it is connected and properly seated.

Hope this helps. :)

Do you know if there is a way to strike the projector sans the high end hardware?

There is, but it involves removing the projector completely and losing control of zoom and focus in the process.....I don't recommend this.

There is, however, an option via the fixture's menu (or via CMA) to set Lamp On "Always" as opposed to the "DMX" or "Manual" settings.

Hope this helps. :)

Dave,

Out of curiosity, have you tried a new lamp?

When the white LED is going solid, it is because the DL is trying to strike the lamp. When it can't strike, it starts blinking. After a short period of time, it goes solid again because its trying to strike again. You could just have a blown/bad lamp.

If you try a new lamp and that doesn't work, try looking at what the indicator lights on the projector itself are doing. Take the back bezel off the head of the DL.3 and look up into the head on the upper right hand corner of the projector. There are 5 indicator lights up there. If you tell me what they are doing while the fixture is trying to strike the lamp, I can help narrow down the problem.

Thanks,