DL.3 Problem,

Hi,

I have 2 problem with our dl.3

First one, I have a dl.3 that wont powerup. The motor etc start but the server wont start. To make it start I need to jump the power pin inside the computer enclosure, even if everything is wired correctly it wont start like if the ‘vitual’ button that start the engine isn’t working.

Second one, I don’t have access to the screen, I don’t know which cable send the Menu to the screen but I don’t get it. I See that its powered and it’s backlit but no menu.

Thanks!

0 andre - Former HES Forum Member over 13 years ago

Hello Anthony,

First problem:
Please press and hold the upper and lower button next to the display.
This will act as power switch for the internal server.
You are on the right way, if the server is switching on!
If the server stays off again after power cycle, it is probably a wrong setting in the Bios.

Second problem:
There is a yellow plug connected with the grafics card, check if this is seated properly, as this is the source for the Front panel display.

With best regards
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 alloalex - Former HES Forum Member over 11 years ago

[QUOTE=Andre;58267]
Please press and hold the upper and lower button next to the display.
This will act as power switch for the internal server.

That's realy cool!
Thanks a lot!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 mayli - Former HES Forum Member over 11 years ago

Hi Anthony,

Do you still have to power up the server manually?
If so, you may replace the BIOS battery, restart the server by hand and the next time it will start up by itself as usual.
You can get a BIOS battery in any electronic store.

The model is CR2032.

Best Regards

Mayli
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel