Source 4 labeling

Contact your friendly neighborhood ETC dealer for purchase.  These may help...

7060A4033
19º Lens tube label, white text (for black fixtures)

7060A4034
26º Lens tube label, white text (for black fixtures)

7060A4035
36º Lens tube label, white text (for black fixtures)

7060A4036
50º Lens tube label, white text (for black fixtures)

7060A4073
19° Lens tube label, black text (for white fixtures)

7060A4074
26° Lens tube label, black text (for white fixtures)

7060A4075
36° Lens tube label, black text (for white fixtures)

7060A4076
50° Lens tube label, black text (for white fixtures)

7060A4094
750W Handle label, black

7060A4095
Label, 750W Handle, White

that is exactly what i needed, thank you

Or you could make your own with a Brother P-Touch labeler and have something nifty to label many other things, too. The label tape is available in a variety of widths and colors, including white text on black tape, just right for a Source 4. It's laminated too, so the text won't wear off.

Paint pen works nicely, too.

We ended up just painting ours and dropped the labels.  Tremclad works well and with colours it is easy to tell each fixture apart without having to read a label.  Really handy when looking at a rig that is in the air.

Thanks for the addl info, i was also thinking about doing the color coding based on the color dots on the lenses but i would always forget which is which so maybe doing both a sticker as well as the colors would work well.  

For the P Touch idea, i have one of those, i figured they would not work because of the heat, i thought that the labels ETC makes would stand up better to the heat on the fixtures/ceiling better, have you had good luck using the P Touch on your light fixtures?

Thanks for the addl info, i was also thinking about doing the color coding based on the color dots on the lenses but i would always forget which is which so maybe doing both a sticker as well as the colors would work well.  

For the P Touch idea, i have one of those, i figured they would not work because of the heat, i thought that the labels ETC makes would stand up better to the heat on the fixtures/ceiling better, have you had good luck using the P Touch on your light fixtures?

I wouldn't worry about the "750" stickers, unless you're in a venue that must distinguish very old lamp caps from newer ones.One can (almost) always tell by the 750's additional plastic handle.

I like white/silver paint pen indicating the degrees on the bottom of the lens tube. AND color coding the colorframe runners, but the question then becomes, "Which colors to use?"

ControlBooth - Labelling S4s

Following the lens dot colors is a good idea, but with some massaging:

19°;-Red Dot, (lens all the way at the front)...RED paint

26°;-Black Dot...WHITE paint

36°;-Dotless, (only STANDARD tube that uses two lenses)...BLUE paint

50°;-Yellow Dot, (lens almost all the way at the back)...YELLOW paint

[EDIT: The forum isn't recognizing/respecting Chrome 32.0.1700.107 's Carriage Returns.  Had to use Firefox 27.0.1. On Mac OS 10.9.1.]

It's been covered reasonably well in mgarrison's post in this thread:

http://community.etcconnect.com/forums/t/10457.aspx