Coloursource Par will not snap out ??

I have a quantity of coloursource par units running firmware 1.4.0.9.0.19 and if you try to snap the fixture out using a fader movement or grand master the unit fades gradually ?

Does anyone else have this issue ?

Cheers

Druuka over 7 years ago

I believe that is a "feature" If you take it out in a 0 count with a cue it will snap. Otherwise it will fade as if it was a light bulb.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
ueliriegg over 7 years ago in reply to Druuka

It's an algorithm that checks of you are sending changing levels or just snap to zero. And you could update the firmware, I think they worked on that logic
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
JOKIN over 7 years ago in reply to ueliriegg

I think the same, it´s a feature, but in our case, and with last firmware too, don´t responde linearly to fader movement.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Denis Twomey over 7 years ago in reply to Druuka

Doing some testing recently I noticed exactly the opposite. Using a fader, it snaps out but in a cue with time set to zero, it fades.
Denis
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
jolsson over 7 years ago

Yea, on some... some time... I had problem a few times with different fade-out curve on different lights, giving a uneven look.. it's not OK from a ETC LED at that price.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Denis Twomey over 7 years ago

I have just updated the firmware to 1.5.1 and it seems to have cured the problem, The pars now snap to zero as expected. However, one of them is intermittently losing the green LED. Any ideas on this?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel