Coloursource Par will not snap out ??

I have a quantity of coloursource par units running firmware 1.4.0.9.0.19 and if you try to snap the fixture out using a fader movement or grand master the unit fades gradually ?

Does anyone else have this issue ?

Cheers

Parents

Druuka over 7 years ago

I believe that is a "feature" If you take it out in a 0 count with a cue it will snap. Otherwise it will fade as if it was a light bulb.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Druuka over 7 years ago

I believe that is a "feature" If you take it out in a 0 count with a cue it will snap. Otherwise it will fade as if it was a light bulb.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

ueliriegg over 7 years ago in reply to Druuka

It's an algorithm that checks of you are sending changing levels or just snap to zero. And you could update the firmware, I think they worked on that logic
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
JOKIN over 7 years ago in reply to ueliriegg

I think the same, it´s a feature, but in our case, and with last firmware too, don´t responde linearly to fader movement.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Denis Twomey over 7 years ago in reply to Druuka

Doing some testing recently I noticed exactly the opposite. Using a fader, it snaps out but in a cue with time set to zero, it fades.
Denis
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel