Controlling Coloursource PAR using RDM and DMX Cat

Hello all!

I seem to be unable to control other features than the DMX adress of the Coloursource PAR using RDM. I have a couple of lamps mounted in hard to reach positions and would like to change the mode to Direct -6channel mode. They are currently in RGB mode. I am using a DMX Cat. Of course it might be possible that it is this product that is causing my issue also.

I am considerng doing a factory reset (which seems to be accessible remotely) since it seems someone has changed their behaviour to put out light when no DMX is present -which is not a function I want. But I am unsure what mode they will start up in after that.

Any suggestions are welcome.

Thanks,

Peder

Parents

corey cascio over 7 years ago

Hi Peder,

6 Channel Direct Mode is a new Feature of CS Par that was only added with a recent Firmware Update. Maybe

the fixtures you have, have an older Firmware that don't Support mode changes.

Please see the CS Fixture v1.5.1 (current Firmware) Release Notes for instructions to upgrade:

http://www.etcconnect.com/WorkArea/DownloadAsset.aspx?id=10737490530

Hope that helps!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Peder over 7 years ago in reply to corey cascio

Thanks -that at least answeres my question if not solves my problem. Like I mentioned the fixtures are hard to reach and the firmware upgrade seems to require access to the fixture itself. A pity it could not be updated over RDM. Sigh. So the remaining question for me is whether I can get rid of the pesky NO DMX -> light output issue remotely by doing a fixture reset over RDM.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
corey cascio over 7 years ago in reply to Peder

Hi Peder,

you don't Need to get to the fixtures to do an update. Using UpdaterAtor Software you can reach the fixtures via RDM using an ETC Net3 or Response Gateway or an ETC Gadget USB to DMX Adapter. Using our Net3 Concert Software you can change the Preset or turn them off via RDM through one of the before mentioned devices without getting to the fixtures.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

corey cascio over 7 years ago in reply to Peder

Hi Peder,

you don't Need to get to the fixtures to do an update. Using UpdaterAtor Software you can reach the fixtures via RDM using an ETC Net3 or Response Gateway or an ETC Gadget USB to DMX Adapter. Using our Net3 Concert Software you can change the Preset or turn them off via RDM through one of the before mentioned devices without getting to the fixtures.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data