Networking

Networking Discussions Response Gateway as Splitter

Date Ezequiel52125
Date Mon, Jun 26 2017 8:08 PM
Replies 3 replies
Subscribers 105 subscribers
Views 3326 views
Users 0 members are here

Response Gateway as Splitter

Is it possible to configure a 4 port gateway as a stand alone splitter for a guest console that only speaks DMX through one universe?

I mean to configure one port as DMX IN and the other three as DMX OUT and use the gateway without a ethernet connection.

Regards.

E.-

Parents

corey cascio over 7 years ago

Naturally. Use Concert Software to configure exactly as you have described.

You will need to use an Ethernet Connection to configure, but then after its configured,

then no more Ethernet is needed.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

corey cascio over 7 years ago

Naturally. Use Concert Software to configure exactly as you have described.

You will need to use an Ethernet Connection to configure, but then after its configured,

then no more Ethernet is needed.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

marcusbirkin over 7 years ago in reply to corey cascio

It's worth nothing that this feature was accidentally removed in firmware v7.0.0, but will be restored in v7.0.1
It is however it is available in the previous release v6.0.1
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Joe Berman over 7 years ago in reply to marcusbirkin

To clarify, yes this can be done in firmware v7.0.0 but you need to have the gateway connected to a network switch/hub. Even if the switch/hub has nothing else connected to it, the gateway needs the network connection.

As Marcus pointed out to me, a loopback cable could be used too. Basically the gateway needs the ethernet port to be active, but doesn't need to use the ethernet port to send/receive.
[edited by: Joe Berman at 9:29 AM (GMT -5) on Tue, Jun 27 2017]
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Top

Related