Can Net3 talk to Net2?

Hello all,

I know this has to be answered somewhere already but I can't find it.

My venue is currently running primarily on a Net2 System. I believe my 4 port Gateway in FOH is going bad. We purchased a new one but of course we got a Net3 one not knowing they were no longer backwards compatible. Can I leave all the nodes that are running ETC Net2 and swap out the Gateway and still have everything work together, or do I need the Net2 nodes converted to Net3, to make it work. What about my CEM + Modules? Do they need to be changed or software updated?

Thanks

Parents

tdrga over 7 years ago

Net3 and Net2 devices do not talk to each other, but many products can talk to both. What console are you using?

CEM + can receive both Net2 and Net3, but would need to be configured so that they are responding to the same addresses.

Was the bad gateway used for input or output?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
jsarge36 over 7 years ago in reply to tdrga

Console is an Avo Lite. My FOH gateway is my primary input to my other nodes, that I change between Outout and Input as needed. I'll need to check my CEM's version.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

jsarge36 over 7 years ago in reply to tdrga

Console is an Avo Lite. My FOH gateway is my primary input to my other nodes, that I change between Outout and Input as needed. I'll need to check my CEM's version.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

Richard over 7 years ago in reply to jsarge36

Which particular Avolites console?

Most of the Avolites consoles natively speak sACN.
- I believe that all the "Titan" family with an RJ45 network jack can speak sACN/E1.31 (Net3's DMX), though it may need a software update. If it's a "classic" console then it probably won't.

So it's likely that your console can talk directly to the CEM+ and Net3 DMX Gateways across the network with a little bit of configuration (possibly with software and firmware updates).

However, Avolites consoles don't speak ETC-Net2 (EDMX) and so would need an ETCNet2 Node/Gateway to be able to talk to ETCNet2-only Nodes.

I'd recommend that you do a quick hardware survey, and find out exactly which network-connected hardware you've got and the software/firmware it's running.
Then get in touch with ETC technical services via email, they can help you figure out the best (most performant/lowest cost) approaches to upgrade.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel