Power Controls and Distribution

Sensor and Matrix Dimming systems Help with Load Reporting on Ion w/ CEM+

Date bill.rios.tpac
Date Fri, Sep 19 2014 5:46 PM
Replies 4 replies
Subscribers 67 subscribers
Views 4675 views
Users 0 members are here

Help with Load Reporting on Ion w/ CEM+

Can someone please help me with the steps to get my Sensor+ AF dimmers to load report to my Ion?

Here is what I've done so far.

1. Upgraded CEM+ to latest software via Updaterator

2. Ran Load recording (via web interface) on CEM+

3. Went to <Patch> in Ion and went to device list

4. <attached> my dimmers

I also made sure they AF Cards installed.

Is that right?
Now what?

Ion v2.2.0

CEM+ v3.1.9.0.44

Thanks,

Bill

corey cascio over 10 years ago

Hi Bill, what type of Module do exactly have? Its printed on right side of Dimmer. D20? ED15? ED15AFR?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
bill.rios.tpac over 10 years ago in reply to corey cascio

D20AF
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
bill.rios.tpac over 10 years ago in reply to corey cascio

Okay, I think I've gotten to a good place. I've gotten the ION to recognize the Dimmers but now I'm getting a yellow ? meaning offline. Not sure what to do next. I tried enabling the ACN on all the dimmers via the patch in the webpage, but still no luck.

Also do not have control of the dimmers via the board now...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
bill.rios.tpac over 10 years ago in reply to corey cascio

Okay, so I got it working. For some reason the ION dropped its IP address. after that I had control again. Then I had to do another Load Record from the Rack. Then finally I got Load reporting on the ION! Then we unplugged the two Fresnels we were using for testing and now I'm getting a load error on the empty dimmer even after another Load Record at the Rack... Oh well, TGIF. See ya next week.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Related