AHHH! Sensor Plus CEM Problem?

On our newly installed Sensor plus Rack (3.5 Months ago), controlled by a CEM +, I just looked at the screen on the module and it was all random characters!!! Although all the dimmers seem to be working, I haven't had the true chance to check if this is true yet. I will be back in there tomorrow to investigate this further and possibly call ETC Tech, but I was wondering if anyone has any helpful tips before I check it out tomorrow.

Thanks a bunch, Sam

Parents

corey cascio over 15 years ago

Howdy Sam,

Sorry about the junk on your CEM+ Display. When you get back to the Rack, pull the CEM+ Processor Module and push it back in - which causes it to restart. You can pull it out by pushing the white Ejection symbol on the front side in the middle bottom and then pulling on the lever until the whole CEM+ pulls out.

Once restarting, it should be back to normal. What Firmware is displayed on the display at restart?

thanks!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
GregThomas over 15 years ago in reply to corey cascio

Corey Is correct. This is a known issue which has to do with the LCD screen itself, and does not effect the performance of the processor in controlling the dimmers. If it keeps happening please contact your Authorized Service center for evaluation of your processor.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
beachcombah over 15 years ago in reply to GregThomas

Hey guys, obviously, that did work when i tried it today. The firmware was 2.2.0 when it restarted so thats about it!

Thanks as always =SAM
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

beachcombah over 15 years ago in reply to GregThomas

Hey guys, obviously, that did work when i tried it today. The firmware was 2.2.0 when it restarted so thats about it!

Thanks as always =SAM
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data