Beacon LEDs

There are a number of conditions that could cause this.  Most likely it is a burned out beacon board.  There could also be issues with the beacon harness that runs from the backplane to the beacon board or (less likely) there could be an issue with the backplane or CEM+ itself.  

There is also a chance that the CEM+ may not be fully seated in the rack.  Removing it and giving it a good push in may prove to be enough.

Hope this helps.

Thanks for your input, I ejected and reinserted the CEM+ to no effect. On closer inspection, after I turned the dimmer room lights off, I noticed that the beacon was lit, but really dim.

I've seen that on Classic racks- those LEDs are often faded. The + racks I haven't seen that yet.

If it's out of warranty it's a pretty cheap little board to buy, and simple to replace.

I've serviced numerous job sites where the LED appears to be inoperable, but upon further inspection, the LED's are just heavily coated with dirt/dust.  If you open the door and look at the three LED's you may find the same issue.  If you're comfortable doing so, clean them off and you may see an improvement in their intensity...

-Abby

Thanks so much for your help everyone, I grabbed a little step ladder and took a look at the leds; they're squeaky clean, so I'll let my boss know about his options if he wants to take action.

Thanks so much for your help everyone, I grabbed a little step ladder and took a look at the leds; they're squeaky clean, so I'll let my boss know about his options if he wants to take action.