I started a new gig in January as the only tech of a small music department and have a 96dim Sensor rack that says it is having air flow problems.
This would alarm me but I did some work in this hall for my predecessor and well four years ago it was flashing the same error message and it does not seam to be effecting anything.
the air filter on the front door seems to be very clean and the dimmers a little bit dusty but not bad for the age of the system. I think this entire setup was installed back around 1995.
So where should i go to understad the proper airflow of the rack?
I can reset the system and the error will go away for a min or two but then comes back.
I have attached a photo of the control panel. I could also use help identifying the model number since this is pre CEM or CEM+.
Thanks for the Help
[edited by: rhdgs at 5:49 PM (GMT -6) on Sat, Apr 24 2010]
