Sensor 3 + TPSR

Hi everyone,

My theatre has a Sensor 3 rack. I am trying to set up the TPSR system. I bought a wireless access point to connect to the CEM 3. My question is, where do I plug in the wireless access point? Do I plug  the ethernet cable into the ethernet port on the front CEM 3? 

Any help would be much appreciated. 

Thank you.

Parents
  • Is your rack controlled via Network sACN? If yes, then it must be connected to a switch somewhere - and that switch you connect to the access point. 

    If your rack is only connected to DMX, then as a temporary solution you can connect to that front port, but you should your ETC Service Contractor come and connect the cable inside the rack more permanently. 

    Here are guides when setting up a network.

Reply
  • Is your rack controlled via Network sACN? If yes, then it must be connected to a switch somewhere - and that switch you connect to the access point. 

    If your rack is only connected to DMX, then as a temporary solution you can connect to that front port, but you should your ETC Service Contractor come and connect the cable inside the rack more permanently. 

    Here are guides when setting up a network.

Children
Related