Sensor 3 + TPSR

Hi everyone,

My theatre has a Sensor 3 rack. I am trying to set up the TPSR system. I bought a wireless access point to connect to the CEM 3. My question is, where do I plug in the wireless access point? Do I plug the ethernet cable into the ethernet port on the front CEM 3?

Any help would be much appreciated.

Thank you.

Parents

corey cascio 2 months ago

Is your rack controlled via Network sACN? If yes, then it must be connected to a switch somewhere - and that switch you connect to the access point.

If your rack is only connected to DMX, then as a temporary solution you can connect to that front port, but you should your ETC Service Contractor come and connect the cable inside the rack more permanently.

Here are guides when setting up a network.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
vpp 2 months ago in reply to corey cascio

Hi!

Our rack is controlled by DMX A only. The sCAN is turned off on the rack.

Thank you for the help.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
corey cascio 2 months ago in reply to vpp

The link wasn’t added to my last message. Here are network tips:

support.etcconnect.com/.../Network_Design
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

corey cascio 2 months ago in reply to vpp

The link wasn’t added to my last message. Here are network tips:

support.etcconnect.com/.../Network_Design
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data