SmartBar hook up to Express 24/48 system

Hi Jeff,

There are a few things to check :

- What is the DMX LED on the Smartbar doing? This is the LED on the lower left side of the display. It should be lit solid when DMX is present. If it is blinking then DMX is not being recieved by the bar

- If the DMX LED is on solid but there is still no control, you might need to check the patch in your Express to make sure channels 25-28 are patched. See the manual in the patch section.

- How is the system wired? It sounds like the 5 pin DMX cable is running from your Express, to the Smartbar, and then out of the Smartbar to your SmartPacks, and the Smartpacks are working OK- right?

- Try plugging the Smartbar directly into the Express with a short length of known working cable. Does that work?

If it still doesn't work there might be a problem with your Smartbar. In that case the best thing to do is to call Technical Services at ETC and we can help you out getting it fixed.

Tom

Thanks Tom,

I'm working on the Express on Wednesday and I'll your suggestions.

The DMX on the SmartBar doesn't flicker, so there is a signal and I've tried plugging it directly but that hasn't worked. The Bar works on its own when a light is mechanically controlled.

I've wired the Bar and the Express in every conceivable way and the Express works perfectly fine with or without being connected to the Bar.

I'll check the patch channels on Wednesday.

Jeff

Thanks Tom,

I'm working on the Express on Wednesday and I'll your suggestions.

The DMX on the SmartBar doesn't flicker, so there is a signal and I've tried plugging it directly but that hasn't worked. The Bar works on its own when a light is mechanically controlled.

I've wired the Bar and the Express in every conceivable way and the Express works perfectly fine with or without being connected to the Bar.

I'll check the patch channels on Wednesday.

Jeff