Dimmer channels @ full even when set @ 1%

Hello

I am using ETC ION v2.7.3 Fixture library v2.7.2.7. All my generic/static fixtures are patched to dimmers but some of these channels/dimmers come up @ full even when at 1%, the Sensor dimmer rack is correctly set for dimmers, non of the dimmers are set for non-dim, any advise will be very much appreciated. Thank you

Parents
  • Hello, Guillermo:

    Does the snapping follow any pattern in the rack, such as an entire phase?  If so, please power your sensor rack off from the main feed breaker and then power it back on.

    Also, in the Ion please check the CURVE column in patch and make sure a number has not been assigned there.


    Thank you,

    Sasha

  • Hi Sasha, 

    Thank you for your quick response,

    I have tried before resetting two-three times the Sensor Dimmer Rack with no luck, I have also reset the LX console a few times with no luck either. 

    I have checked the curve in the patch as suggested but all is cleared

    Note that the issue happens only in a few dimmer/channels not all. All the LED and movers work fine ... 

  •  Hello, Guillermo:


    Thank you for the clarification.  Which dimmers?  Is there a pattern?
    It could be the CEM and not the console at this point.  If you set them to 10% and look at about in the dimmer's menu, do you see 10% or 100%?


    Thank you,

    Sasha

  • Hi Sasha and thank you for following my issue.

    In the dimmer rack I have swapped modules in where is thought or suspected to have bad module but the result is the same, if I drive the dimmer from the dimmer rack and set it at 20% the display shows 20% but the actual output in the fixture still is at full. I have checked the dimmer rack being correctly set up, I have compared the setting on the dimmers that behave fine with the ones that don't and the settings are exact the same. Any other thought?

    Thank you very much for all your help.

Reply
  • Hi Sasha and thank you for following my issue.

    In the dimmer rack I have swapped modules in where is thought or suspected to have bad module but the result is the same, if I drive the dimmer from the dimmer rack and set it at 20% the display shows 20% but the actual output in the fixture still is at full. I have checked the dimmer rack being correctly set up, I have compared the setting on the dimmers that behave fine with the ones that don't and the settings are exact the same. Any other thought?

    Thank you very much for all your help.

Children
  • Guillermo, let's double-check Sasha's question about whether the affected dimmers follow a pattern.

    If you physically look at the rack, are the modules you're having an issue with clustered together by any chance?  Assuming this is an install tower of 96, are the problematic circuits all in the top,. middle, or bottom third by any chance?  

    If there is no obvious pattern that way, what dimmer numbers are having problems?

Related