CEM+ dual Processor Configuration

Hi to all,

I've some issues regarding the setup of dual CEM+ processor on a ESR36 SENSOR + Rack.All the setup are ok on each processor, modification on A processor is copy on the B processor.But, the lower processor keep going to be the master and the upper one still the slave. If i remove the B processor the A become the master but when the two are online, the B is always the master.

I've try to wire a remote switch for a manual action without sucess no action at all. (Wiring with J12 connector with 12v on panic connector).

Thx for help.

Regards

corey cascio over 13 years ago

on the left handside of the rack is a black plastic cap. below it is a switch. it should be set to the middle for automatic and not down for B. what theater is this?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Richard over 13 years ago

As Corey said, check that the A/B switch is in the centre position.

If this switch isn't working correctly, check it's correctly plugged into J13 "Local Select" 3-pin connector on the rear of the backplane, immediately below the bottom-left ribbon cable (J11 Distro 1-24)

It's possible to plug this in 1-pin-out which prevents the switch from working correctly, and a short from debris in this connector can easily force Processor B to be in charge.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
DavidTSO over 13 years ago in reply to Richard

Hi ta all,

I'm feeling silly to didn't notice that switch!! thx a lot Corey and Richard.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel