• Date
    Aaron46816
  • Date
  • Replies 2 replies
  • Subscribers 93 subscribers
  • Views 628 views
  • Users 0 members are here

0-10V circuit in DRd with D20

The theater I volunteer at recently had a construction project that replaced some of the lobby lighting.  The new (non-ETC) fixtures utilize 0-10V control.  I was surprised to see in the DRd rack that those circuits still have D20 dimmers installed in them.  I thought that any circuits that utilize 0-10V control should also have an R20 module installed.

Is my understanding wrong, or did the installer make a mistake or take a shortcut?

Parents

  • It's likely they are using the 0-10V card inside the DRD rack for the dimming control.  

    If the power supply/ballast is being powered by the D20 that's another story.

    If you 0-10V light is on, and you physically breaker off the D20 does the light go off in the space? 
    There's always a chance they landed the old circuit from the DRd rack into some panel board?

    And yes a CC20 or R20 would be recommended, R20 being preferred.  Does a D20 work, sure for a bit, but you are still going through the choke of the dimmer and the driver is getting a clipped power signal, which overtime (basically a little mini electrical hammer hitting the electronics inside the driver) is going to cause issues to the 3rd party driver/ballast.  Could last 2 hours, 2 day, 20 years, you never know.

  • in reply to Chris Stokes

    This is exactly what I was thinking.  Thanks for the input.  I'll see what details I can confirm.

Reply Children
No Data
Related

www.etcconnect.com