Can not seen any fixtures using Gadget RDM

Hi,
I'm trying to program the modes of a Desire D60XTI. I'm using the Gadget together with a dongle. In Patch I have the Device Discovery set to Enabled. And the fixture gets DMX signal.
Still there are no fixtures popping up in the RDM device list.
Someone who has an Idea?

Thanks Marnix Kuling

0 JasonPerry over 10 years ago

I have the same setup on my system. Gadget, Nomad Dongle. I see RDM and can get communication with my fixture. I have RDM discover enabled in Console Settings, I don't think I made any other changes to settings. Are you running latest software 7.1? Do you have any other RDM tools to test the device? How many D60XTI are in the chain and how long is the DMX line running to it? I do not believe the D60XTI are self terminating so it may be a problem with the data line and not the console.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 ueliriegg over 10 years ago in reply to JasonPerry

And you have no old DMX splitters or boosters in the line?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Richard over 10 years ago

Ensure that RDM is enabled for the Gadget (DMX Port 1) in Browser > General Settings > DMX Settings.
Note that you need a complete, terminated DMX line and we recommend against using any splitters/boosters - though if there are then they need to fully support RDM.

RDM Splitters and boosters are not recommended as they tend to make RDM very slow!
- RDM has quite low bandwidth and splitters consume some overhead as well as allowing many more fixtures to be on the line.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel