• Date
    lidgett
  • Date
  • Replies 6 replies
  • Subscribers 68 subscribers
  • Views 12476 views
  • Users 0 members are here

Connecting ArtNet to Congo

OK, I give up.  I've been trying to connect my computer to Congo via ArtNet to run an couple of things I've downloaded of the net that are ArtNet compatible, but I can't get the board and the PC to talk to each other.  Could someone give me a step by step on how to network together the two.  I can't find any real clear instructions on how to do this!

J. R. Lidgett
Salina Community Theatre

Parents

  • So the information about switches, etc. that others have given you is all good information.

    Let me give you a step-by-step from the last time I set it up.

    1. Make sure your console IP address is in the 10.101.x.x subnet.
    2. Make sure the receiving device is also in the 10.101.x.x subnet (actually you can get away with 10.x.x.x).
    3. Enable artnet.
    4. Set your artnet broadcast address to 10.255.255.255 .
    5. Reboot your console.
    6. In patching your devices, keep in mind that every output protocol on the console starts with the first universe of its particular protocol as universe 1.  Unfortunately, ArtNet actually refers to its first universe as universe 0 internally.  Therefore congo 25.1 is Artnet Universe 0, Address 25.  Just a little trick to be aware of.

     

  • in reply to Tracy.Fitch

    Tracy,
    The universe issue was the problem.  I had everything else set up right, but couldn't get the it to do anything since I was apparantly patched incorrectly.  Thanks for your help, this has been driving me crazy for some time!

    J. R. Lidgett
    Salina Community Theatre

  • in reply to lidgett

    Dear Richard,

     

    I want to connect a Congo Full size and A Light Server as Server Backup and I want both to be connected to Pathways and to output artnet (Pathway). How is that possible? Can I have a step by step guide???

Reply Children
No Data
Related

www.etcconnect.com