MIDI time code

Problem:

• You need to recall a preset when the incoming MIDI Time Code source matches a specific value.

Proposed Solution:

1.       Turn on the "Time Code" parameter in "Play Settings - Show Control".

2.       Turn on "Auto - loacte step" parameter in "Play Settings - Show Control".

3.       If needed: Record the Preset. By default, a Sequence Step is automatically added to the Sequence in the Main Playback for this Preset.

4.       Locate the Sequence Step in the Sequence and modify the value in the "Time Code" column.

All this information is based solely on reading the Congo v6.0 User Manual and has not been tested.

-Marcus

Thanks.  I have figured how to enter a specific time for within the time code column in the sequence list.  What is missing is getting the first preset to start the timecode.

Regards,
Orri

I do not believe there is a way to have the internal clock started by running a sequence step or a preset. You could try starting the internal clock by triggering an Action Macro from an incoming MIDI data signal sent from QLab.

-Marcus

It could have to do with that you start with 00:00:00:00

Usually what you do is to start with 01:00:00:00 and have something like 3 seconds pre-roll, to give all the equipment  a chance to sync with the timecode.

Hope the helps

Bullen

It could have to do with that you start with 00:00:00:00

Usually what you do is to start with 01:00:00:00 and have something like 3 seconds pre-roll, to give all the equipment  a chance to sync with the timecode.

Hope the helps

Bullen