dot or comma

This has been written up as an issue - [A3D-154] Support commas in decimal input

I will add your comments to that issue.

Thanks -MattP.

I think this should be a setup item, the use of a comma or a dot is most country specific, so in D-A-CH countries you use comma as a separator but many CAD programs use a dot as default.

I'm sure it happened because of the country settings in windows, but I think Eos (and with that also Augment3d) should always use the same. And since Eos always uses . Augment3d should also use that, no matter what the country settings are.

I'm sure it happened because of the country settings in windows, but I think Eos (and with that also Augment3d) should always use the same. And since Eos always uses . Augment3d should also use that, no matter what the country settings are.

I agree because the separator in patch use comma for separating xyz coordinates.
Also the item "Snap Distance" in Argument3D Preference Editor Settings use comma instead of dot, this should also changed. Maybe there are some other items.
The problem is not Windows specific it happens also on macOS.

maybe i'm misunderstanding? but in patch xyz are separated by / 

Chan 1 Position 1/2/3

and probably i should have said "the operating system's country settings" instead of being windows specific.

In patch it looks like this

ah yes, but that's not how you enter the information

i agree for . everywhere (which would allow to keep caps locked while entering values

capslock behavior is also country dependent. in most languages Caps Lock only affects letters, but not symbols...

indeed  my system is in french config; but i keep my eos in english, french translation is harder to get than the original ;)