sgm g profile pan inverted

Hey Al!

I am seeing in this config that the patch for ch1-12 has half of the fixtures with inverted pan and the other half with inverted tilt, so I am not sure of the problem here based on the intententional programming.

- are all the fixtures locally set without any inverted parameters at the fixture?

- if you start a new patch with just one fixture without any inversion in the eos patch, do the movements match the fixture?

- it could be that we did not have the correct values for P/T, but those can be input by following the below article:

support.etcconnect.com/.../Fixture_Physically_Pans_or_Tilts_in_the_Opposite_Direction_from_Visualized_Movement

Hi, TJ

Thanks foer the answer. 

I tried a new show with little time, and if i invert pan range it works. 

Unfortunately i can't do it with an already programmed show, but that's ok, i'll do without.

Thanks again

Ok let us know if you are still seeing issues!