sgm g profile pan inverted

Hey Al!

I am seeing in this config that the patch for ch1-12 has half of the fixtures with inverted pan and the other half with inverted tilt, so I am not sure of the problem here based on the intententional programming.

- are all the fixtures locally set without any inverted parameters at the fixture?

- if you start a new patch with just one fixture without any inversion in the eos patch, do the movements match the fixture?

- it could be that we did not have the correct values for P/T, but those can be input by following the below article:

support.etcconnect.com/.../Fixture_Physically_Pans_or_Tilts_in_the_Opposite_Direction_from_Visualized_Movement

Hi, TJ

Thanks foer the answer. 

I tried a new show with little time, and if i invert pan range it works. 

Unfortunately i can't do it with an already programmed show, but that's ok, i'll do without.

Thanks again

Ok let us know if you are still seeing issues!

Ok let us know if you are still seeing issues!