Cameo Hydrabeam 4000 RGBW on Augment3d

Question

Good Afternoon 
 I'm currently working on a showfile with Augment3d for a show in which I have to use several Cameo Hydrabeam 4000 RGBW fixtures. They are existing in the fixture library but somehow i can't get them to move in Augment3d unlike I can with other movinglights. They just behave as a conventional four-cell fixtures instead of four, more or less, independent Movingheads sitting on a common bar. 
 To be able to setup the desk and preprogramm bevor the show and not being in the venue it would be extremly helpful when these four heads (beams) of the Hydrabeam could move also in Augment3d. so i would be able to see, what I'm programming. 
 
 I'm wondering if it's me doing something wrong or if it's a bug within the fixtureprofile/Augment3d-Model. 
 
 Any help would be highly appreciated. 
 Thanks, 
 Markus

eos moderator · Accepted Answer

I wouldn't consider this a bug, Augment3d currently just doesn't understand this type of fixture. 
 Looking at the profile there doesn't seem to be a reason for those 4 heads to be 1 multicell device if you're running in 56 address mode. With this mode you should be able to split the cell from the profile and patch it as four channels.

Cameo Hydrabeam 4000 RGBW on Augment3d

Top Replies