Cameo Hydrabeam 4000 RGBW on Augment3d

I wouldn't consider this a bug, Augment3d currently just doesn't understand this type of fixture.

Looking at the profile there doesn't seem to be a reason for those 4 heads to be 1 multicell device if you're running in 56 address mode. With this mode you should be able to split the cell from the profile and patch it as four channels.

Sorry for my extremely late reply.

Thanks für the Tip - running the fixture in 56 address mode and patch it as four indipendent channels did the trick. Not only in the preprogramming state with the aid of aument3d but also in the venue.

Thanks very much.

 P.S.: the show (a highschool choir concert) was programmed offline by me and then run by some highschool students on a Element 2 Console 

Sorry for my extremely late reply.

Thanks für the Tip - running the fixture in 56 address mode and patch it as four indipendent channels did the trick. Not only in the preprogramming state with the aid of aument3d but also in the venue.

Thanks very much.

 P.S.: the show (a highschool choir concert) was programmed offline by me and then run by some highschool students on a Element 2 Console