Hello!
I have some JB Lighting P9 and P10 and the zoom is not linear in real life. in A3D the full out zoom and minimum zoom is matching real life but not in between. the zoom is slow start and actually start to get bigger at 7-10% this making A3D always to big except at full out and minimum zoom.
Is it some way to edit this to match?
Thanks, Johannes
I had a look at the zoom behavior of a P18 today. It's a bit more complicated than it looks at first glance, but I assume it's similar with P9 and P10.
A P18 has a zoom range of 7 to 56°. With Edge=0 there is no zoom change in real life between Zoom 7 and 23. But with Edge=100 zoom changes are visible from the very beginning.
Zoom=7 and Edge=0 shows about the same beam size as Zoom=28 and Edge=100.
So the problem is actually twofold:
Finally: you can modify the fixture profile to help with non-linearity, but unfortunately you'll loose the encoder's value being displayed.
I had a look at the zoom behavior of a P18 today. It's a bit more complicated than it looks at first glance, but I assume it's similar with P9 and P10.
A P18 has a zoom range of 7 to 56°. With Edge=0 there is no zoom change in real life between Zoom 7 and 23. But with Edge=100 zoom changes are visible from the very beginning.
Zoom=7 and Edge=0 shows about the same beam size as Zoom=28 and Edge=100.
So the problem is actually twofold:
Finally: you can modify the fixture profile to help with non-linearity, but unfortunately you'll loose the encoder's value being displayed.
