Hi guys, just wondering whether you are planning to release OSC support for commands like Staging Mode, XYZ Focus Enable/Disable or fixture position in the nearby future?
Loving the new EOS, good job everyone
Luis
Hi guys, just wondering whether you are planning to release OSC support for commands like Staging Mode, XYZ Focus Enable/Disable or fixture position in the nearby future?
Loving the new EOS, good job everyone
Luis
/eos/key/staging_mode or /eos/key/Staging_mode work. Send it twice to Clear Staging Mode
/eos/xyz 1.0, 0.0, 0.0 will set the currently-selected channel to position X=1.0, Y=0.0, Z=0.0
/eos/chan/1/xyz 3.0, 2.0, 1.0 will set Chan 1 to position X=3, Y=2, Z=1
>>Note: this position is *always* in Meters, for consistency.
/eos/cmd=Chan 1 XYZ_Format Disable# or /eos/cmd="Chan 1 XYZ_Format Enable#" should change that setting. Note that it does need to be terminated, with the #.
Great, this works like a charm. This leads me to another question: is there a way to retrieve the position of a fixture? (some sort of /eos/out/chan/1/position or similar)
It's not currently possible to get the XYZ focus of an arbitrary channel. You can receive the XYZ focus of the currently-selected channel using /eos/out/xyz:with a result like
/eos/out/xyz, -0.500(f), -10.318(f), 0.000(f)
Thanks Matt, I meant the XYZ position of the fixture in Augment3d rather than the XYX focus but I've checked and it is possible to write Position and Orientation in the command line via OSC so all sorted (I thought it wasn't possible as they're not yet in the OSC Keys in the Manual along Staging Mode or XYZ Format)
Thanks Matt, I meant the XYZ position of the fixture in Augment3d rather than the XYX focus but I've checked and it is possible to write Position and Orientation in the command line via OSC so all sorted (I thought it wasn't possible as they're not yet in the OSC Keys in the Manual along Staging Mode or XYZ Format)
www.etcconnect.com