learning/recording an event sequence with lights triggered by an external sound to light source

Hi,

in this setup I use luminosus with sound to light to trigger a light source in ETC nomad. Everything works fine, as long as I just let the sound file trigger the light via luminosus. Now I need to record that in a timecode sequence. If I rund the sound file like before the light gets triggered but there is no event sequence recorded.

When I do the triggering of the light manually, hitting my submaster button, the timecode sequence is recorded. 

Is it not possible to record a event sequence when the light is triggered by an external source? Any hints would be great:-)

Btw.: this only works one older machines, MB 2015, and not on a new one like MB 2021 silicon, because luminosus and the sound to light software don't run on the newer ones.

Is there by any chance an other way to get lights triggered by sound?

All the Best

Rainer

Parents
  • Hey Rainer,

    we use "Lightjams!" with a very basic setup on a laptop that gets the sound input from the sound console (XLR --> 3,5mm jack :D). We connect a simple USB to DMX device to this laptop and the DMX goes to a merger that merges this and the ETC's signal (HTP). This way, our sound to light is always a "live" input, and no recording is needed (an actor speaking makes the simple RGB LED blink in blue). So this solution is quite independent of the ETC desk, and the only reasonable way we found...
    Quite a workaround, but it worked fine for already hundreds of shows. If the sound to light is more complex, I bet Lightjams is also capable of that, but we never needed any more than this.
    So I hope this helps a little anyway.

    Best,
    Thorben

  • I’m thinking they want to avoid having to live capture the sound during the show and simply playback what is produced during cue writing. 

Reply Children
No Data
Related