HyperDeck Ethernet Protocol (TCP) - Sending from EOS.

Question

Hi All, Looking at trying to start and stop a Blackmagic Hyperdeck Recorder. Problem is it seems to only use TCP. Is there any way to send a TCP Command using HyperDeck Ethernet Protocol (TCP) to this without adding another piece of hardware in between. I have looked into adding a ESP device on the network to be a translation hub. Just trying to figure out an easy way to set the recorder to record on Q1 and end of last Q of show - without having to physically push record. 
 Or is there any roadmap to send TCP messages like the UDP from within EOS? 
 Cheers.

Matt Pumplin · Answer

I do not believe this is currently on the roadmap. You can request that a feature be added here: Eos Family Feature Requests 
 I think you might be able to use ETCLabs/OSCRouter: UNOFFICIAL - Simple UDP/TCP packet router for Mac and Windows, with optional OSC specific options to perform this task if it were installed on a computer somewhere in the system. Just be aware that while this software was built by ETC engineers, ETC does not support it directly and Tech Support is not familiar with its usage.