Patching

Hi,

you can write Adresse(soft key) 1 @ 5 Enter

Now the DMX-Adresse 1 give you a output with 50%.
When you claer the command line, you have no output.

Now you can search the device and patch it.

hope that helps

I'm wondering if you are refering to the set up in the West Las Vegas Theater?  If so, email me for the long story answer to what the dimmer numbers are.  :-)  Short version is- the achitechutral system was modified to accept dmx commands from a console.

Thanks Brian, but unfortunately this is not what I am looking for.

Mike,

Is there a way to move through DMX addresses using the next and last keys like with the channel check feature?

For example, Channel 1 @ 50%; press next to illuminate next light and extinguish previous light simultaneously.

yes you can syntax would be Address "1" @ 50 enter then you can next and last from there and it should do the next address in line.

Because your bringing up addresses every time you either clear the cmd line or hit next or last, the current address will go out and bring up your next Address without the need of specifying Channel check for regular patched channels. 

From the live table, select soft key S2 {Address} then press @ and the level you want.  Next and last should scroll you thru just like channel check.

When I press the "at" key, it enters 'address' into the command line instead of '@'. Is this normal?

Are you in patch?  For the address check to work you need to be in the Live Table

Do I need to be in patch for it to work?

You don't want to be in patch.  You want to be in the Live Table.

Thanks. This is just what I needed